Water Reservoir, Electrical Specifications, and Requirements, Optional Plumbing Kit

It is essential to the operation of the ES.1 to meet local plumbing and electrical requirements.

Water Reservoir

Each ES.1 is shipped from our factory pre-programmed to be used with the included 3L Water Reservoir located in the bottom of the machine.

• All water used in the reservoir should meet the specified water quality standards.

Electrical Requirements

The ES.1 was designed to optimize the espresso experience. The ES1 is available in 100-120V and 200-240V setups. An electrical socket and matching plug, rated at the proper voltage and amperage, are required within three feet of the machine. Incorrect voltage can cause malfunction or damage to the ES.1. Plug or means of isolation must be easily accessible. ES.1 includes an appropriate cord and plug depending on region.

Table 1. Electrical Specifications

ES1 Model	Voltage	Frequency	Current (Amps)	Watts (Max)	Current Phases	Power Cord
120 V	100-120 VAC	50-60 Hz	14.8 A	1800 W	Single	US 120 V Plug
240 V	200-240 VAC	50-60 Hz	9.9 A	2400 W	Single	Plug Depending on Region

Optional Plumbing Kit

Plumbing Requirements

The ES.1 is shipped standard to be used with the included internal water reservoir located at the bottom of the machine.

There is an optional plumbing kit available upon request. This kit is intended to be installed by a service technician. If you want to plumb your ES.1 please contact our customer service team for assistance. We can help find a service technician in your area.

Important: When installing the ES.1 with the optional plumbing kit to connect to the ES.1 to your water mains instead of using the internal reservoir, all national and local ordinances should be followed, with particular attention to limiting back siphoning of water in the appliance back into the water supply. Use only ASSE 1022 certified or equivalent devices, such as the Watts Type SD-2 or Zurn Wilkin Type 740 backflow preventers. Installation should be preformed by a Service Technician. If you are interested in plumbing your ES.1 please contact our customer service team so we can help you find a Service Technician in your area.

The ES.1 requires a water supply capable of delivering water at 30 gals (120 L) per hour.

Note:

Synesso sells a “Euro-hose” adaptor hose and fitting, which converts from a 3/8” tube fitting to a pipe fitting, suitable for most non-US plumbing.